A new type of "Sensor" physics object is available in the GE for advanced
collision management. It's called Sensor for its similarities with the
physics objects that underlie the Near and Radar sensors.
Like the Near and Radar object it is:
- static and ghost
- invisible by default
- always active to ensure correct collision detection
- capable of detecting both static and dynamic objects
- ignoring collision with their parent
- capable of broadphase filtering based on:
* Actor option: the collisioning object must have the Actor flag set to be detected
* property/material: as specified in the collision sensors attached to it
Broadphase filtering is important for performance reason: the collision points
will be computed only for the objects that pass the broahphase filter.
- automatically removed from the simulation when no collision sensor is active on it
Unlike the Near and Radar object it can:
- take any shape, including triangle mesh
- be made visible for debugging (just use the Visible actuator)
- have multiple collision sensors using it
Other than that, the sensor objects are ordinary objects. You can move them
freely or parent them. When parented to a dynamic object, they can provide
advanced collision control to this object.
The type of collision capability depends on the shape:
- box, sphere, cylinder, cone, convex hull provide volume detection.
- triangle mesh provides surface detection but you can give some volume
to the suface by increasing the margin in the Advanced Settings panel.
The margin applies on both sides of the surface.
Performance tip:
- Sensor objects perform better than Near and Radar: they do less synchronizations
because of the Scenegraph optimizations and they can have multiple collision sensors
on them (with different property filtering for example).
- Always prefer simple shape (box, sphere) to complex shape whenever possible.
- Always use broadphase filtering (avoid collision sensor with empty propery/material)
- Use collision sensor only when you need them. When no collision sensor is active
on the sensor object, it is removed from the simulation and consume no CPU.
Known limitations:
- When running Blender in debug mode, you will see one warning line of the console:
"warning btCollisionDispatcher::needsCollision: static-static collision!"
In release mode this message is not printed.
- Collision margin has no effect on sphere, cone and cylinder shape.
Other performance improvements:
- Remove unnecessary interpolation for Near and Radar objects and by extension
sensor objects.
- Use direct matrix copy instead of quaternion to synchronize orientation.
Other bug fix:
- Fix Near/Radar position error on newly activated objects. This was causing
several detection problems in YoFrankie
- Fix margin not passed correctly to gImpact shape.
- Disable force/velocity actions on static objects
Implementation of the PHY_IPhysicsController::SetMargin(),
GetMargin(), SetRadius() and GetRadius() for Bullet and Sumo
to allow resetting the Near sensor radius. For bullet use
the new setUnscaledRadius() function to change sphere radius.
In pPreparation of a Fh constraint actuator:
- Add KX_IPhysicsController::GetRadius()
- Fix implementation of KX_BulletPhysicsController::GetVelocity()
(velocity at a point in geometric coordinate)
- Don't try to set velocity on static object (Bullet will assert)
- Add KX_GameObject::GetVelocity() for C access to local velocity
(adding)
#ifdef HAVE_CONFIG_H
#include <config.h>
#endif
also the Makefile.in's were from previous patch adding
the system depend stuff to configure.ac
Kent
--
mein@cs.umn.edu
