DGK6X = Venus, Hades, Galaxy, etc.
This DGK6X code is shared between the ANSI variants of Venus, Hades and Galaxy keyboards.
- Keyboard Maintainer: J-Sully and dkjer
- Hardware Supported: Durgod Venus, Hades or Galaxy board with STM32F070RBT6
- Hardware Availability: Venus, Hades and Galaxy
Instructions
Build
Instructions for building the Venus, Hades and Galaxy firmware can be found here:
Initial Flash
For first Flashing from initial Stock's Firmware
- Back up original Firmware Image:
- Unplug
- Short Boot0 to Vdd (See below)
- Plug In USB
- Make a Flash Image's Backup in case you wanted to restore the Keyboard to Stock's Image:
-
Using dfu-util:
dfu-util --list dfu-util --alt 0 --dfuse-address 0x08000000 --upload ${OLD_STOCK_BIN}
-
- Flash the QMK Firmware Image.
- Put board into Bootloader mode, using the same method as when backing up the original Firmware (above)
- Here are a few options for performing the initial Flash:
-
Using QMK Toolbox
-
Using dfu-util:
dfu-util --alt 0 --dfuse-address 0x08000000 --download ${NEW_QMK_BIN}
-
You can short Boot0 to Vdd by shorting R19 to C30 on the sides closest to the processor, as shown:
-
Hades & Venus:
-
Galaxy 75
Subsequent Flashing
For repeating Flashing you can use BootMagic:
- BootMagic Lite has been enabled with Assigned "Esc" key
- Unplug USB Cable
- Holding Esc Button
- Plug in USB Cable, Keyboard should be in ST-Bootloader state