Ferris sweep

A version of the Ferris keyboard that uses a daughterboard, designed by the fantastic @davidphilipbarr with some input from @pierrechevalier83 for the copper pad. All PCB files are available on the project's github page

Keyboard Info

Keyboard Maintainer: Pierre Chevalier
Hardware Supported: Sweep (all versions)
Hardware Availability: Print the PCB with gerber files from the repository

Make example for this keyboard (after setting up your build environment):

make ferris/sweep:default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

Bootmagic reset: Hold down the top left key on the left half (or the top right key on the right half) and plug in the controller on that side.
Physical reset button: Briefly press the reset button soldered on the PCB.
Keycode in layout: Press the key mapped to QK_BOOT if it is configured.

Swapped Pins

If you printed one of the PCB variant with swapped letters Q and B / P and N, add the following code to your keymap's config.h to swap pins E6 and D7 in the firmware:

#undef DIRECT_PINS
#define DIRECT_PINS { \
    { D7, F7, F6, F5, F4 }, \
    { B1, B3, B2, B6, D3 }, \
    { D1, D0, D4, C6, E6 }, \
    { B4, B5, NO_PIN, NO_PIN, NO_PIN } \
}
#undef DIRECT_PINS_RIGHT
#define DIRECT_PINS_RIGHT { \
    { F4, F5, F6, F7, D7 }, \
    { D3, B6, B2, B3, B1 }, \
    { E6, C6, D4, D0, D1 }, \
    { B5, B4, NO_PIN, NO_PIN, NO_PIN } \
}