3dortho14u
A symmetrical 14u wide ortholinear keyboard.
In addition to the 3d printed parts and microcontroller, the following hardware is required:
- 8 * 12 mm M3 bolt
- Either:
- 8 * M3 muts and CA glue OR
- 8 * 3x3 mm threaded insert
- Optional:
- USB daughter board
- Keyboard Maintainer: xia0
- Hardware Supported:
- rev1: Teensy 2.0 (ATmega32u4)
- rev2: Arduino Pro Micro (ATmega32u4)
- Hardware Availability: github
Make example for this keyboard (after setting up your build environment):
make 3dortho14u/rev1:default
Flashing example for this keyboard:
make 3dortho14u/rev1:default:flash
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
Bootloader
Enter the bootloader in 3 ways:
- Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
- Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
- Keycode in layout: Press the key mapped to
QK_BOOTif it is available