Patch from Jaggz H, thanks!
[#31096] Weight-painting: Brush-specific weights
http://projects.blender.org/tracker/?func=detail&atid=127&aid=31096&group_id=9
Each brush's weight can now be set individually, can also enable
unified setting (same as size and strength have.)
Added readfile code to the patch: subversion bumped to 1, brushes get
default weight of 0.5, unified weight enabled by default and value
from old vgroup_weight field.
- makes wireframe from faces.
- options similar to inset (even offset, relative scale)
- copies face settings and loops (uvs, vcolors)
- optionally replaces the existing geometry.
Sponsored by the Blender Development Fund.
http://www.blender.org/blenderorg/blender-foundation/development-fund/
Remarks:
The original code was not designed to support moving obstacles so I had to introduce some velocity constraints into the code to prevent smoke from exploding. If this causes problems with "fire" emulation, please let me know.
Expose option into interface to use modal solver which currently
supports only tripod motion.
This solver requires two tracks at least to reconstruct motion.
Using more tracks aren't improving solution in general, just adds
instability into solution and slows down things a lot.
Refirement of camera intrinsics was disabled due to it's not only
refines camera intrinsics but also adjusts camera position which
isn't necessary here
To use this solver just activate "Tripod Motion" checkbox in
solver panel.
Merged from tomato: svn merge ^/branches/soc-2011-tomato -r45622:45624 -r46036:46037
P.S. Quite experimental yet, requires more checking and probably
tweaks to prevent camera jumps when tracks apperars/disappears
from the screen.
* Remove RNA, Operator and UI for Texture and Sequence plugins.
Since 2.5x no effort has been done to bring that back, so there is simply no reason in keeping that code and the UI for that ;-)
* Low Level code still exists and is unchanged.
* Fix an alignment issue, column_flow layout apparently does not use the whole width, leaving a small gap on the right side. This should be fixed in the layout engine, but too close to release now.
Note: Supporting obstacles which can be enabled/disabled as animated propoerty is not likely to happen. So I marked this as "Won't fix"/TODO.
I also reverted last commit on this bug because it didn't work and disabled the property from UI to avoid confusion.
from user freedback it seems there are 2 use cases, both valid.
* Select geometry and cut the selection in half (as 2.4x worked)
* Point-to-point define the faces to cut, dont cut through everything (only cut what you see).
With the second, since you are already selecting the edges to cut and snapping to them. only cutting the selecting is limiting/annoying.
Modifying these options while the knife tool runs doesn't work well, so expose under 2 keys, K, Shift-K.
Disable operator register and redo flags because it might modify non-mesh
data when in edit mode. This doesn't work properly with current undo stack
design.
* Replaced the hard coded viscosity presets with Python ones.
* Added version check, so older files load fine.
Loading new files into 2.62 also works fine.
Expose option into interface to use modal solver which currently
supports only tripod motion.
This solver requires two tracks at least to reconstruct motion.
Using more tracks aren't improving solution in general, just adds
instability into solution and slows down things a lot.
Refirement of camera intrinsics is supported by this solver.
To use this solver just activate "Tripod Motion" checkbox in
solver panel.
Previously it used to use cursor location from time when panel was drawn,
which in some cases lead to using previous cursor location instead of current.
* Negate label in the Vertex Groups panel was misleading to the string buttons, rather then the check boxes. Fixed it by having 2 columns.
Not ideal still, but better! :)
Issue reported by Tobias Kummer. Thanks!