Use assert(Not)Equal()
Use assert{Greater,Less}[Equal]
Change-Id: I7c14570b8dce463ee13a67e9c1f10beb1a0308a8
Signed-off-by: Paul Vinciguerra <pvinci@vinciconsulting.com>
only learn from a GARP packet if it is an update to an existing entry.
Change-Id: I4c1b59cfedb911466e5e4c9756cf53a6676e1909
Signed-off-by: Neale Ranns <neale.ranns@cisco.com>
and update glean address on local interface MAC change
Change-Id: I530826d60c7e9db2b0fa2d45754139d82c5ea807
Signed-off-by: Neale Ranns <neale.ranns@cisco.com>
This reverts commit 8b30e471df4d42214619e1d6c50cc8298426b45f.
Change-Id: I99edb236eb0a7f8ba3fba333c3481a710ebcb59c
Signed-off-by: Ole Troan <ot@cisco.com>
update the glean adj on a local interface MAC change
Change-Id: Ia5c5cde424ed0fea3431532cc5abf22b364bbab5
Signed-off-by: Neale Ranns <nranns@cisco.com>
part 2;
- this adds the code to create an IP and MPLS table via the API.
- but the enforcement that the table must be created before it is used is still missing, this is so that CSIT can pass.
Change-Id: Id124d884ade6cb7da947225200e3bb193454c555
Signed-off-by: Neale Ranns <nranns@cisco.com>
When VPP has an interface whose address is also applied to a TAP
interface on the host, then VPP's TAP interface will be unnumbered
to the 'real' interface and do proxy ARP from the host.
the curious aspect of this setup is that ARP requests from the host
will come from the VPP's own address.
Change-Id: Ia238790e1034ba3cd3facdab29387b65a31525f2
Signed-off-by: Neale Ranns <nranns@cisco.com>
Check whether an ARP src hw addr starts with 00:00:5e:00:01
before rejecting due to a mismatch between ARP src hw addr
and ethernet frame src addr.
Change-Id: Ia3ecd5d6dba34876aca8d90bc622a0a1397e48fb
Signed-off-by: Matthew Smith <mgsmith@netgate.com>
learn ARP peers if, 1) it's a reply to a local address, 2) we are sending a response to a request.
send proxy ARP responses only in the interface the request was sent.
Change-Id: I22b949c65122824233076492b7dd537daca07bc2
Signed-off-by: Neale Ranns <nranns@cisco.com>
allow this config to function:
set int ip address loop0 169.254.1.1/32 (the default GW address for attached hosts)
set int unnumbered af_packet0 use loop0 ('enable' IP on the host interface)
ip route add 192.168.1.1/32 via af_packet0 (where to find the host)
repeat for each host and host interface.
Inter-host communication is throught the /32 routes.
To allow this:
1 - attached host routes have the ATTACHED flag set, so the ARP code accepts then as legitimate sources
2 - unnumbered interfaces inherit the source address from the IP interface
Change-Id: Ib66c5f0e848c528f79372813adc3a0c11b50717f
Signed-off-by: Neale Ranns <nranns@cisco.com>
